why neutral and earth should not be connected on 3 phase
440v/50c/s supply at consumer side. where as on
25kv/ac/50c/s railway traction substation neutral and earth
will be connected and track at substation. and track will
act as neutral and earth. Reasons for this is needed
urgently
Answer Posted / shivababa_1812
electrical engineering
Is This Answer Correct ? | 1 Yes | 12 No |
Post New Answer View All Answers
what is value of Jin transformer
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
what is the mechanical safety of DG ?
what is the transformer rush current?
can i connect REF and Differencial relay in 1 CT core for transformer protection?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
What are protections for dty type transformers
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
how single phase preventer works ?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
hello if any one have papers vof hpcl or sail, plz send me