Interested to Buy Any Domain ? << Click Here >> for more details...
what is the value of current and voltage that our body can
resist ?
- 3 Answers
- 6536 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikram veer singh
the typical values for current are given below :-
BODILY EFFECT DIRECT CURRENT (DC) 60 Hz AC 10 kHz AC
------------------------------------------------------------
Slight sensation Men = 1.0 mA 0.4 mA 7 mA
felt at hand(s) Women = 0.6 mA 0.3 mA 5 mA
------------------------------------------------------------
Threshold of Men = 5.2 mA 1.1 mA 12 mA
perception Women = 3.5 mA 0.7 mA 8 mA
------------------------------------------------------------
Painful, but Men = 62 mA 9 mA 55 mA
voluntary muscle Women = 41 mA 6 mA 37 mA
control maintained
------------------------------------------------------------
Painful, unable Men = 76 mA 16 mA 75 mA
to let go of wires Women = 51 mA 10.5 mA 50 mA
------------------------------------------------------------
Severe pain, Men = 90 mA 23 mA 94 mA
difficulty Women = 60 mA 15 mA 63 mA
breathing
------------------------------------------------------------
Possible heart Men = 500 mA 100 mA
fibrillation Women = 500 mA 100 mA
after 3 seconds
------------------------------------------------------------
since the resistance of human body is about 1 mega ohm.
so calculate the voltage by ohm's law..
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What type of pipe material G.I or M.S is used for sprinkler system?
If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
11000volt DG set carnt kaise banvay
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
Alternator rotor earth fault relay circuit
I want d.g.set our company
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
how we provide neutral earth on synchronising panel as per electrical standards?
how can i reduce sparking without stepdowning the voltage
What is the purpose of stablization resistor in high impedance bus bar protection
In Plumbing services What are accessories we consider for a bathroom?
Differentiate between voltage and current feedback in amplifiers?
how calculated Transformer losses.
