Answer Posted / k.prakashchandra
It is for rotor wound induction motor in which the
resistance is included in rotor winding with the help of
slip rings
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
what happen ehen synchronisation is done at below rated speed
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
what is KSR type transmission tower? What is LSR type transmission tower?
What is dynamo?How it works and what is the function of dynamo in a DG.
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
What is the difference between a fuse and a breaker?
what is the difference between b c d curves on mcb
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
what is the voltage between earth to neutral in lift.
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
What mean by MLTP
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .