Answer Posted / deepak mishra
actually slip is there in case of induction motor and it is
(Ns-N) the difference b/w the synchronous speed and the
actual speed of motor.
as synchronous motor run always with synchronous speed so
slip is Zero in case of synchronous motor.
| Is This Answer Correct ? | 18 Yes | 0 No |
Post New Answer View All Answers
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
Explain different types of d.c motors? Give their applications
If short circuit ratio is high is it bad or good for a machine then tell the reason...
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
is it possible to test of bus bar in high rise building without completed full floor ?
Sir, I m 3rd year student 4m DCE and want to do internship in siemens or l&t or any other mnc related to electrical engineering. please tell me the procedure 4 same and oblige me
What happened when voltage will half value of current ...
How grounding is different than earthings?
What OPGW is better than Microwave or PLCC???
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
Why efficiency in thermal power plant is low?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
What is the function of interposing current transformer?
what is the basic need of domestic loads 1- voltage 2- current
