why commutator is attached with only dc macine
- 8 Answers
- 10946 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / aviral
commutator is unit which converts AC voltage into
Unidirection DC Voltage. The voltage generated in the DC
machine is in alternating nature. Because of this reasion
commutator is attached with DC machine.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
how you configure motorvision relay (L&T make)from DCS
What is transformation ratio what it describes?
PLZ EXPLAIN THE INTERLOCKING AND CONTROLLING OF CONTACTORS????HOW CAN I DO THAT?
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
Define pole pitch?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
should %impedance be high or low in a power transformer? if so why?
how to identify conection leads of an unknown electric motor
what do w do when the output of generator is fluctuating?
What are the advantages & disadvantages of a group electrive drive?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
