The DCS stand for________________________. it is composed of
the following major components:
a:______________
b:______________
c:______________
d:______________
Answer Posted / khalil ahmad khan
DCS stands for :Distributed Control System".
DCS System consists minimum of the following components.
1. Field Control station (FCS): It consists of input/output
modules, CPU and communication bus.
2. Operator station: It is basically human interface
machine with monitor, the operator man can view the process
in the plant and check if any alarm is presents and he can
change any setting, print reports..etc.
3. Engineering station: It is used to configure all input &
output and drawing and any things required to be monitored
on Operator station monitor.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
How does temperature bath work? How does coil gets heated only by applying some current?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
what would be the minimum flow rate that we can measure on rotameter..?
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
Any body have know try work calculation ???
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
Do you have reference list?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
Speedtronic system .