Answer Posted / chandan kumar
SARVO MOTOR
| Is This Answer Correct ? | 2 Yes | 14 No |
Post New Answer View All Answers
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
how to setting voltage RTCC panel
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
Define peak time.
How can we calculate the KVA rating of a Distribution transformer from its core details?
i need mat lab program to find out the transmission line losses,regulation and losses
Which type of transformer is used for lighting loads?
Please brief what is sinewave
what is the maintaining Cf in UPS.
explain the functions of main isolation switches
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
What are the electrical engineer roles and responsibilities in chemical plant?
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
