is 3-phase induction motor need a starter ? why do it so
Answer Posted / avvkishore
safety and protection purpose
Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
what r the safety measures in UPS ? explain all?
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
how to control the speed to switched reluctance motor
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
How you calculate the repturing capacity of a HRC fuse
in science exhibition how lamp can blink when you clap near the lamp ? thank you
how to extend relay operating timing in 24V dc relay card (without using Timer )
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
what is the formula for hv test for cable and circuit breaker..????
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
what is the acceptable limit value for Desolve Gas Analysis/