what will happen if the input of a transformer is dc?
- 10 Answers
- 8981 Views
- Hindalco, I also Faced
- E-Mail Answers
Answer Posted / roshan
if the in put of a transformer is DC then steady current will
flow due to which change in magnetic flux will not take place
& induced emf will not be produce & therefore the transformer
will not work
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
For overhead protection we use which transformer?
What are the specifications for getting approval of Substation?
placement paper samples of mspl company
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
How to convert a two phase power into a three phase power in induction machine?
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
What do you mean by per capita requirement of electrical energy in india
The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
what is meant by skew width in machines?
ht side line to earth voltage
