what will happen if the input of a transformer is dc?
- 10 Answers
- 8992 Views
- Hindalco, I also Faced
- E-Mail Answers
Answer Posted / roshan
if the in put of a transformer is DC then steady current will
flow due to which change in magnetic flux will not take place
& induced emf will not be produce & therefore the transformer
will not work
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
Is potential difference materials property ..? if yes tnen how.. explain brifly.
what is the Pickup/drop off ratio in BCPU relays
how to find the multiplication factor for digital energy meter and analog energy meter
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
why we cannot protect 100% winding of an alternator by using differential protection?
What is meant by impedance? difference between high & low impedance ?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
What are the advantages of the three-phase motor over single phase motor?
which capacity of RCCB used for five thousand watt electricity load?
Difference between HRG and NGR. Are they both the same thing
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
