Answer Posted / venkadesh777
it is the field bus &communication protocol.developed by
modicon
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
how many type of plug are used in pneumatic control valve,name them.
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
i am having information technology branh ....... can i prepare for psu exam
Explain about the leakage class of the control valves
what are the different types of Protocols? & their applications.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Draw block digram for well head from well to shipping pump?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
What is the use of each wire in three wire RTD
What is wet leg condition and why is it used?
What is the use of single seated valve?
you are on site,the plant trips,you are approached by operations,what do you do?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
How to calibrate capillary type level transmitter
