wat is the difference between real power and reactive
power..which is useful..?and how it s useful..wat is the
effect of these on a power system...
- 10 Answers
- 20718 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / pkd
real power is that which is really consumed by a load(resistive load) & which can not be reactive again or which can not be transferred to the source by the load.
reactive power is that which is consumed(inductive load)or store (capacitive load)power for a certaim period of time which can be reactive,that is which can be transferred to the source from the reactive load(capacitive/inductive)for another certain period of time.
so real power is caused due to the electric energy which actually/really works to transform into heat or another means of energy in the load(resistor),but reactive power is due to the energy which is not actually lost due to the friction or anything other in the load,rather it can be transferred to the source again.
now it is easy to say what is more important or both are important..
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
WILL SCHNEIDER MAKE ACB(MASTERPACT)TRIP ON REVERSE POWER?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
What do you mean by a voltage transformer?
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
What is the formuala to calculate the rating of motor protection circuit breaker
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
Can anybody tell abt concrete encased earthing or grounding?
what is load vs Torque curve & why it is used?
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
what is negative d.c. voltage, why this voltage is used in base transciever station.
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
how maney type tempereture measurement ?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
what is maxemo work permit procedure
