Interested to Buy Any Domain ? << Click Here >> for more details...
Why we are using air gap magnetic condutors
- 2 Answers
- 6766 Views
- Ford, IOCL, I also Faced
- E-Mail Answers
Answer Posted / vijendra joglekar
We are using airgap for decreasing and increasing Magnetic property and current value. I.e if you increase the airgap Magnetic property will be low hence it will increase the current value and the losses will be more.
Similarly if u decrease the airgap the reverse thing will happen. The airgap depends upon the type of equipment you are connected.
| Is This Answer Correct ? | 16 Yes | 4 No |
Post New Answer View All Answers
i applied for the ap transco please forward the freqventley asked QA
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
What are the types of control system?
is there any current and voltage drop on liquid resistance starter water/soda tank ?
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
what is cascade speed control device?and how this device control the speed of motors?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
DG cranking voltage?
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
how does ELR works? explain
