Interested to Buy Any Domain ? << Click Here >> for more details...
EXPLAIN THE WORKING OF SERIES REACTOR IN HT CAPACITOR BANKS
(FOR VOLTAGES & CURRENTS)
- 1 Answers
- 8277 Views
- I also Faced
- E-Mail Answers
Answer Posted / jkjljkb
bjkbkjb
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
reason of diode failure in alternator
what is gridrotor resistance starter
what is DRP panels?
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
Why is a synchronous motor always star connected??
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
How does the slip regulator works as a startor
what is saturation kit?which use above 15 kw motors panel side.
how we decide scurt (disc) of insulator with respect to kv rating
why are the maintaine power factor and how can this control and this is how work.
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
explain working principle of earth leakage relay
working function importance of mdc meter
why do we have spikes enough to burn electronic boards, when generators are not grounded
