Answer Posted / prasanna kumar
rectifies are the process of convertin ac current into the
pulsiating dc current.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which type of devicesa used for detection of radio active field in side the reactor building?
please send previous years question papers of JuniorEngineer (ELectronics)in RRB.
What does ac voltage controller mean?
What is the purpose of bleeder resistance in a rectifier circuit using l-c filter?
Can anyone send me question papers for section engineer for railways and send me on my id- abhay_jg@yahoo.com
Why the degree of valve plugs and valve seat is slightly different I control valve trim design
why ac waveform repesented by using sine wave why not others?
What is the necessity to use the special machines?
What are the properties of roc for z-transform?
Explain difference between dcs & plc & scada?
# What is D-FF? # What is the basic difference between Latches and Flip flops? # What is a multiplexer? # How can you convert an SR Flip-flop to a JK Flip-flop? # How can you convert an JK Flip-flop to a D Flip-flop? # What is Race-around problem? How can you rectify it?
in govt polytechnic lecturers tell me what is the expected cut off for ece after the interview list announced
what is difference b/w watt loss and watt full devices. what is watt loss and watt full devices?
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
define conversion time.
