What is working principle of washing machine?
- 9 Answers
- 88712 Views
- IBPA, Samsung, I also Faced
- E-Mail Answers
Answer Posted / s.palanisamy
when switch on the machine,it feeds water suficient quantity and sensor stops water,sominimum water is required.then washing is started with pre set time as per program and then water is drained.
| Is This Answer Correct ? | 18 Yes | 30 No |
Post New Answer View All Answers
Why is remote backup preferred to local backup?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
Why is better to have a minimum ceiling voltage of 250% than 160%?
how to enter inverter parameter? without manaual?
what is meant by tranformer impedance?
how to build a network which step down 415v to 1v rms
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
My question is abt backlog.I had dropped one subject in my second year, and completed this subject in the 3rd attempt, so how many backlogs i have got?1 or 3?plz sujjest the answer as soon as possible
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
why r we using shell transformer for low voltage
What is “pu” in electrical engineering?
State the types of distortions in amplifier?
