Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sharad
A soft starter is a solid state motor starter that is used
to start or stop a motor by notching the voltage waveform,
thereby, reducing the voltage to each phase of a motor and
gradually increasing the voltage until the motor gets up to
full voltage/speed all at a fixed frequency. The profile of
the increase of voltage depends on the application. The
voltage is reduced and controlled by 3 pairs of back-to-back
silicon-controlled rectifiers (SCRs), which are a type of
high speed thyristor. A soft starter takes the place of a
contactor and can also take the place of an overload relay
in a standard motor starting application.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is POTT and PUTT explain?
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
please send privious years question papers of jindal steel and power ltd.My e mail id is rajanikant.sngh@gmail.com
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.
Pls explan the OLR setting in VCB at HT yard
what is the condition for YnD11
what is the difference between STAR and DELTA connection and application wise how it can be utilizedd
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
in conventional fan regulators how the current varies with speed?
what is servo motor & how does it work.
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
