Answer Posted / vignesh.raja63
we have see inside of the part object and shapes
| Is This Answer Correct ? | 3 Yes | 16 No |
Post New Answer View All Answers
Dear Sir, i need previous technical question papers, if possible so please tell from where i got these papers.
What is the materials of jib?
What is forced convection?
Relatesd Applied Mechanics
Why is the suction pipe of vapor compression and refrigeration system insulated?
my jindal interview is on 24th.. can anyone give me few tips regarding the same? lik how i shud prep
How many cylonders are there in 2stroke diesel engine?
What is the boiler bank position?
why is heat treatment of steel metal crucial?
what are the activities to be done after a steam turbine trips?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
Which reactor uses primary coolant as fluoride salts of lithium, beryllium, thorium and uranium ?
Why is it that the maximum value which the residual stress can reach is the elastic limit of the material ?
are BS, BSP, BSW threads same?
What do you going to observe, when a diesel engine is running?
