Answer Posted / fahran
Trans, working just &just on mUtual indiction fundamental.
for step up and step down. not a another.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
Is it possible to measure the voltage of a battery from a single terminal?
what is circuit breaker in transfomer and where it used
What is ideal IR values for ground and neutral.
What is slip in an induction motor?
What is an 86-P or an 86-A trip
What is an order of a system.
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
how to check avr of dg set of 125kva
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
In a single how much maximum current and watts using
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What are protections for dty type transformers
