Answer Posted / jayakannan.s

THE PLC IS WHICH SOLID STATE IN THIS OUT PUT IS DEPEND UP
ON INPUT STATUS AND PROGRAMING CONDTION.

ALSO ALL ALLOCTAION OF HUMAN CONTROLS ARE GIVEN IN TO THE
TECHNICAL EQUIPMET. THIS IS ALSO CALLED AS AUTOMATION.

How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.

1638

---

while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?

1716

---

3. Differentiate between ultrasonic flowmeter and radar type flow meter.

2447

---

what is difference between fork type and capacitance type level switch. where it is using

1936

---

hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel

1524

---

---

hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747

1576

---

what is temperature compensation?

4797

---

What are the interlocks we have to check during the start up of LP/HP compressor?

1500

---

what are the values of fuel flow rate in various places in boiler.

1249

---

Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?

1775

---

how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?

1722

---

what is the input of digital counter during the the calibration time?

1839

---

How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)

2135

---

Describe a time when you anticipated potential problems and developed preventive measures.

2486

---

What is the differerence between hysterisis and linearity.

1831

---