Answer Posted / ajit maurya
Bearing is machine arotating parts by both axial and radial loads element,used for supporting the
mainly two types of bearing
1.Friction bearing
2.Antifriction bearing
Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
Why an increase in area is required to produce an increase of velocity in case of supersonic flow ?
Will a steel cable become longer if it is heated while under load? Explain
where is the steam trap connected in boiler distribution?
What is the usage of draft tube in reaction turbine ?
why stress relieving of stainless steel is not preffered
What ill be the shaft diameter with clearance having a bearing bore is 30mm?
What is the color of flame if the boiler is running in good condition? How about when it is not in good condition?
What are the advantage and disadvantage of using lpg in a car?
why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
What is space heater?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
solar cooker based on the principle
Why and what cause of leak fuel oil in high pressure pipe of main engine?
how long normally does the domestic refrigerant capillary tube are?
what is the function of platern water wall in a boiler? and difference between with ordinary water wall?