Why the resistance grounding (NGR) is better than Solid
grounding?
- 5 Answers
- 11661 Views
- I also Faced
- E-Mail Answers
Answer Posted / jijo
Ngr is using fault current reduced and flow to ground
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
use of PIR in ehv breaker
what is gridrotor resistance starter
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
What about electrical Units. discrive in detail
Differenciate between circuit wiring and sub main wiring with illustrations
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
how to find impedance , mutual indatnce in transmission lines
How to select a cable size for particular load?
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
