Interested to Buy Any Domain ? << Click Here >> for more details...
how many mega ohms insullation of the cable can't be use
when testing with megger tester for Low voltage cable 240V
use?
- 3 Answers
- 6061 Views
- I also Faced
- E-Mail Answers
Answer Posted / utcl
above 10 megaohms
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
how current is reverse from its normal direction during the fault?
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
what happen if drive input fail momentry at 48.5 HZ frequency?
please send me the L&T Emb. sys. placement papers and entire details of pattren
with help of neat sketch explain principle of TIG welding process
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
the typical output of a solar cell is........
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
What does bode plots shows?
the winding of Generator and Motor is star or in delta ? and why
What are the different losses In a de mac1une'! t.xplam
