Answer Posted / navodit verma
actually from 12th standard my inclination was towards mechanics and thermodynamics.as these can be well studied during the course of mechanical engineering. so i chose this branch.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what are the major duties of a mechanical engineer in a power plant.?
What is the purpose of bilge separator
what is the type filter in clean side in ge 9 fa gas turbine ?
What causes cylinder liner-wear down?
sir/ madam i m apearing to rrb bhubaneswar for entrans exam please i want a help to get thruogh this
Machine tool guideways are usually hardening by ?
what is the velocity considering in lube oil drain line for lube of system for steam turbine?
sir, i am going to appear in the test of BEML 2009 so i want to get the type of question paper asked in previous exams of BEML.
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
What are the different theories of failure under static load, explain ?
Low water in boiler drum is unsafe because it may result in overheating of water tubes in furnace. Why it is unsafe to have high water condition in boiler drum ?
What are the symptoms of broke piston ring?
Define reynolds number [re].
What is meant by cross flow heat exchanger?
Question for mech.engineer in dmrc
