Answer Posted / j.karthik(cce)

Generator Protections are:

1. over current protection
2. Earth Fault protection
3. under voltage protection
4. pole slipping protection
5. under frequency protection
6. Impedence protection
7. df/dt protection

Transformer Protections are:

1. Differential protection
2. winding temperature protection
3. Oil temperature protection
4. overcurrent protection
5. Earth fault protection
6. undercurrent protection

Note:

The protection relays are increases deponds on the ratings
of the Transformer and Generator...

what is effect of leading power facter on the system and billing

1792

---

Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job

1649

---

Why 9KV surge arrester having 7.65KV of MCOV?

1111

---

for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?

619

---

what is reverse power relay brief explanation and in b/w where it is connected

1503

---

---

3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.

2241

---

What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?

1632

---

What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV

1602

---

why different series of vfds (like allenbradley)are used in industry ?

1828

---

Explain about retrofitting of machine tool.

1488

---

WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT

1923

---

What is the disadvantage in proportional controller?

638

---

3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?

1408

---

What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i

1598

---

why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain

1735

---