Answer Posted / rajesh
using hart / fieldbus protocol linked with ethernet
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is frequency factor in massflow meter? When using frequency output?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
where proximity sensor installed on tank in loading arm application
what is 24vdc live and dry supply
Describe how to use megger to measure the earth resistance and insulation resistance
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
what is gas metering system? gas chromatograph? and gas compressors?
what is the input of digital counter during the the calibration time?
How to calibration coriolis flow meter?
how to calibrate and troubleshooting of leveltroll?
How to calculate P,I&D value in PID controller ?
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
What is first echo & echo window in radar type level transmitter?
If we increase only P what will be controller action ?
what is the minimum power (P=VI)to produce a spark?
