what is the relevance of knee point voltage in protection
and metering grade CT ? and basically what is knee point
voltage ?
- 2 Answers
- 4786 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishal ingle
Hi Ravi teja,
I am confused whether knee point voltage is lesser than the
saturation value or otherwise.
kindly elaborate your answer in a simple language.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
Keywords: Die, Card, Coin, B/N 2 To 12
How many turns are there in primary winding? (In Transformer)
I need bhel electrical test pattern & paper
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
in dc shunt motor if field winding is shorted then
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
Why front mounted CT polarities are always towards breaker?
how could we calculate the no of outgoings from a 800 watt distribution board
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
what is control supply rating of a machine
How to calculate the copper in HT motors if KW, RPM & Voltage is given
