Interested to Buy Any Domain ? << Click Here >> for more details...
A pressure transmitter with a range of 0-100 bar.The
accuracy of the instrument is 1% of upper range value?
The pressure indicating transmitter is showing the system
pressure is 50 bar.
b. When you include the error, what is the minimum possible
pressure in our fuel gas system?
i. 49.5 bar
ii. 49 bar
iii. 1 bar
iv. 0.5 bar
We want to change the filter cartridge. We must depressure
the fuel gas system.
c. After we depressure the system in preparation for
maintenance, the transmitter displays a pressure of +0.1
bar. At this time, what is the possible range of pressures
in our fuel system?
i. +0.099 to +0.101 bar
ii. 0 to +0.2 bar
iii. -0.1 to +0.3 bar
iv. -0.9 to +1.1 bar
- 3 Answers
- 6917 Views
- I also Faced
- E-Mail Answers
Answer Posted / jaydeepplc
send me practical approach answers,with example ..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is span value and zero ? and how set ?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
How process line mpm calculation is done?
How to fix back the valve actuator stem
What are the interlocks we have to check during the start up of LP/HP compressor?
Difference between ultra sonic flow meter
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Why not come out analog output in ABB EL3020 when display show correct value
How to work togather like sov,limit switch,proxy switch and booster in xv
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
you are on site,the plant trips,you are approached by operations,what do you do?
What is zero elevation and zero suppression?
What is the diffrence between ff tx and non ff tx
kindly sent some demo question and answer
control panel design guidelines
