Answer Posted / vishal ingle
rating is given in KVA / MVA because the power factor of
the lod to be connected is not known. for a specific fixed
real power (MW), the current depends on the power factor.
higher the p.f., lesser is the current & viceversa.
the condustor size inside the trf/ alternator is decided
depending on current.
hence KVA capacity is mentioned always.
Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
what is the minimum winding resistance of 30hp compressor, to run or to switch on
When and where resistance earthing is used ? How to calculate the time constant for earth fault
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
how to carried out DAR test in 11 KV Alternator ?
Disadventage of cable-gland earthing if any ?
Meaning of ingrace protection for motor.for ex IPXY
How the over load setting for HT Motors calculated-provided in Numerical Relay
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
what are symmetrical and non symmetrical components in electrical installation.
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
Can anybody post questions asked in Engineers India Limited Interview? Thanks in advance.
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm