why only 11kv level is used for transmission purpose? why
not 230v?
Answer Posted / dev
Min vol. for transmission is 33 kv not 11 kv
11 kv is max. distribution voltage
Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
draw singleline diagram of star to delta and dol starters
why single CT used in DOL starter power circuit?
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
Can a generator runs after getting 1st stator earth fault.
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
What is power in wattage of 8.5 TR AC
how to work droop ct in generating station
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
what is the responsibility of C license holder in industry?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
What is thresh hold value of current?
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
for a 400kv t/m line with 10 ampere current will corona occur?
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture