How many earthings are provided for a 250KVA distribution
transformer?
- 9 Answers
- 15410 Views
- I also Faced
- E-Mail Answers
Answer Posted / deadzg_devil
Mainly two types of earthing are provided:
1)System Earthing:The neutral is connected to ground so that in case of imbalance the zero impedance current may pass thru the ground.
2)Equipment Earthing:This is provided to safeguard the outter body of transformer in case any fault occurs or any live wire touches the ground , it can redirect the current to ground.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What safety precaution are to be taken for avoiding electric hazards ?
which model T or pie model is prefarable in power syatem
what is the thumb rule for determination resistance of resistor?
explain working principle of earth leakage relay
A 1F capacitor is charged to 100V initially. A 1H inductor is connected accros the capacitor througha a switch. The current in the circiut when the switch is closed is____
mccb service sittings be done?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
What do you mean by dependent and independent voltage sources?
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
