can any tell me how to do wiring connection in L&T 3ph 4wire
E301 CT operated energy meter, what is P1,P2,P3,P0.
M1,M2,M3, L1,L2,L3.
Answer Posted / k.prakashchandra
Generally , P means potential ,M - Mains (incomer) L -load (
line).Po- Neutral.M and L are for CT terminals incoming and
outgoing respectively, when CTs are used
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
what will happen if synchronous machine rotor fed from single phase ac supply
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
how is find out kwh step by step
I am going to appear for the RRB Chennai junior Engineer online exam. Please send me the previous exams question papers (also solved) to my mail id: rrkhandhar@yahoo.com
While testing a ZCT what parameters have to check or measure?
What is the minimum underground tank size capacity considered for firefighting purpose?
What is difference between slip rings and carbon burushes?
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
full form of electrical?
what is meaning of sympathetic tripping with respect to relays and give the values for current carrying capacities for copper and aluminium cables from 16sq mm to 500sq mm
is IS says that neutral should be brought to switch box. and this one is a recomended practice
Difference between transition and diffusion capacitance
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?