Answer Posted / yomama
The walls of the cage contain openings that usually
determine the flow characteristic of the control valve.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
What is the difference between working pressure and calibration pressure of a control valve
How do bending tubing provide better measurement than using tubing fittings such as elbows?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
What is three element drum level control system why its better than single element?
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
what is droop in governer ,type of droop ,how it work
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
Explain PID controller tuning & any one method used for it.
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
Explain the working of an enraf level gauge.
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
