why in industries it is specified as .2 to 1 kg/cm2
Answer Posted / chanees
0.2 to 1 kg/cm2 is the standard Pnematic Signal in foorm of
kg/cm2 ,which is use in Instrumentation
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What you know about iso 9001? What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?
Explain overhauling stopsfor backpull our pumps?
What are the major disadvantages of product grouping?
What is load line in control valve?
what is impeller front clearance of pump ?
what is difference between an encoder & resolver?
What is setup time?
Can we Use AC Servo Motor with Variable Frequency drive instead of Servo Drive? OR with VFD, only simple induction motor can be connected? VFD (Variable Frequency Drive)is having facility of Encoder Feedback.
What is different between preventive maintenance and maintenance?
Difine the process you would establish to monitor the effectiveness of an emergency evacuation system
if zero ohm is not adjusted on shorting the two terminal of multimeter what does it indicate
EXPLAIN WHY YOU CONSIDER YOURSELF SUITED FOR THIS POSITION:
How does pressure transmitter electronics sensor be used to transmit level measurement parameter?
give comparison of three wire & two wire sensors.
what is impeller clearance?