Answer Posted / ravi
Which point is we can take a refrance point for hight of
level .
Means our level is XXX mm from Datum line .
The bottum of measerd level tank is Datum line
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Specific gravity.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
What is the use of temprature compensation?
What is ultrasonic flowmeter?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
Please can anybody help for control valve sizing step by step procedure?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
describe flow nozzel principle?
