There is one 40MVA oil cooled transformer (yet to
commission), filled with 95% oil and we are trying to fill
5% Nytrogen in that transformer so that there should not be
any foreign component inside. But even though there is no
leakage, nytrogen is not withstanding inside transformer,
within a day or two pressure guage is showing 0. Why is it
soooo? Pls reply.
- 1 Answers
- 2943 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Tr is only waterproof (oil)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
I need model question papers for RRB section engineer Chennai... Please send to my E-mail Id:- maitheerainbow@gmail.com
HOW TO CALCULATE THE VT SIZING?
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
What are the factors influence the choice of an electrc drive?
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
how does an encoder work???
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
Why do we use copper cable for HT Supply and why not Aluminium?
Define active and passive network?
what is integrated ac contact circuit
How to calculate the sag on transmission Lines.
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
