Answer Posted / faisal nisar
In a system altered instantaneously say-by closing the
switch of any system the flux linkage must be the same
before and after the system is altered but only for very
small interval of time ,
which is to say flux linkage can not change
instantaneously in a given system .. the conclusion is
described as the principle of constant flux linkage..
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
How could a garment factory benefit from renewable energy
What is the basic principle of welding process?
wat is the first thing dat is needed, 2 lay a cable in some area??
Why 11kv to be generated in generation station
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
can we install HT panel & LT panel side by side or how much clearance is required ?
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
Why Ac Systems Are Preferred Over Dc Systems?
What is meant by derating factor?
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
