Why only 1 CVT in Y-phase
is used for synchronization in 3 phase power system?
- 1 Answers
- 4973 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If only one CVT is opted, it is usually provided in the
middle phase( Y). For synch one phase is sufficient.
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
In motors how many types of cooling systems were used?
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
How to perform a DC resistance test In Alternator and their proceduces?
can you plz send l&t aptitude questions if available its urgent plz plz plz
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
how much GROUND & NEUTRAL VOLT maintain in data center.
what is doubling factor in making current of a breaker?
what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What is different between Circuit breaker and Isolater?
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
What is meant by analogous system?
