Which layer is responsible for putting 1s and 0s into a logical
group?
A.) Session
B.) Application
C.) Transport
D.) Data Link
E.) Physical
F.) Network
- 3 Answers
- 7273 Views
- I also Faced
- E-Mail Answers
Answer Posted / rakesh kumar
D
At the data link layer, Zeros and ones are logically
grouped into frames with a defined beginning and end.
Rakesh Kumar
Fresher (CCNA)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Which table find best path?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
Which type of routing you did in ccna?
What is the difference between static ip addressing and dynamic ip addressing?
Hi Friend. i have to let you know that now i have been selected for cisco india in bangalore. i am thanking to all of you guys that u have been posted such good question and the respective answer. from today i will be not able to visit this site on regular basic and hopeing that you will continue to post the question.the question you are posting is not very usefull to you but also usefull to another. i am again thanking to all of you and hope for best for your feature. Jitendera kumar sinha Network engineer-L2 cisco india Bangalore
Name the command we give for see routing table?
What is ping? What is the usage of ping?
What is the multicast routing?
What is the difference between private ip and public ip?
What is the terminal emulation?
What does protocol mean?
What are some standards supported by the Presentation layer?
Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down
What is the difference between ‘bit rate’ and ‘baud rate’?
What is the purpose of a data link?
