What happen when ct secondary are open circuited? why same
thing is not happen in ordinary transformer?
- 3 Answers
- 6738 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / pritam upadhyay nit p
when secondary is open there ic no flux due to secondary
current to oppose flux due to primary so due to high flux
there is very high voltage induced on secondary side which
causes sparking and damage of core due to high flux demsity.
in case of power transformer flux is constant whtheer
primary open or not so there is no such case as in ct..
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How Can you do Maintenance of ACB of 2000Amperes
Name of the relay of low lub oil presuure in DG sets
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
What is real time power factor control panel(RTPFC)?
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
How 48-relay (incomplete sequence) functions?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
what is frequency response?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
what is the meaning of 5% droop or 7% droop in AVR?
What will happen if the voltage in my house drops from 220V to any lower voltage?
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
how is the connection of a 3 phase ct trivector meter done on a pole mounted transformer
