What is the causes Power Factor become leading and what is the
effect of Electrical system ?
- 2 Answers
- 3624 Views
- I also Faced
- E-Mail Answers
Answer Posted / lucky
electrical power factor leading due to high inductive
circuit
And the effect is high real power and increase in power loss
| Is This Answer Correct ? | 9 Yes | 8 No |
Post New Answer View All Answers
what is kvarh? Please define it With calculation General motors ?
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
What is the function of the generator exciter?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
how to make an earthing certificate
what is a reactive power? what is the relation with power factor?
what is KSR type transmission tower? What is LSR type transmission tower?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
How to set a Zone 1 distance relay for distribution feeder?
