Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mahesh m
The vaccum c.b are used to dissconnect the ckt when fault
accurse in the ckt,aswell as the vcb is used to break the
ckt in abnormall condition,in tn the name indicates the
isolators are used to isolates the ckt and the supply can
be intterupted by the mains.
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
why impedance relay is used for medium transmission line protection
What are the disadvantages of autotransformer?
What is big transformer parts and their function ? Ty
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
how solar power plant energy meter multiplication factor
What is the purpose of stablization resistor in high impedance bus bar protection
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
differnce between single acting and double acting solenoid valves
What are the advantages and disadvantages of open loop control system?
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
why dc is used in control circuit for mv & hv switchgear instead of ac
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
