Interested to Buy Any Domain ? << Click Here >> for more details...
It is desired to reduce effect of 50Hz pick up in a
thermocouple measurement. If a third order LP filter is
used for this, what should be its cut off frequency, if
gain should be 0.001 at 50Hz.
- 1 Answers
- 3918 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / guest
5Hz.This has a -20dB/decade fall off. the required gain is
0.001 or -60dB.Being third order filter, cut off frequency
should be 50/10 = 5Hz
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the procedure of O2 sensor(ABB) calibration?
Why do we have earthing cable in branch cable and shield in the same cable?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
What is Positive Calibration and Negative Calibration?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
what is instrument philosophy
Specify for Cables - Flame Retardant and Fire Resistant?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
Explain signal isolator
What is the minimum rating availalbe for weld neck orifice in market?
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
send me HPCL paper
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
