what is cement mortar cube size and strength in 3days,
7days and 28days
- 6 Answers
- 18907 Views
- JET, I also Faced
- E-Mail Answers
Answer Posted / mahendra mohan srivastava
size is 50cm2
| Is This Answer Correct ? | 12 Yes | 16 No |
Post New Answer View All Answers
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
pls give me some basic informations in construction of a structure?
what is the anchorage length of reinforcement.
hi every body..i have applied for RRB section engineers CIVIL.i wanna prepare for that,so can any one suggest me some books and where can i get the syllabus for this..i would be vry greatful if any one can help in this regard
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
how to do sudoko puzaals?
where tie beam is used? what is the pupose? what dimension of tie beam can provided and number and diameter of steel bars to be used between the columns of 1333mm and 1400.
at which depth the construction of tunnel is economical from cost and engineering aspect.
define the strength
What black man invented the clothes dryer?
how to calculate load bearing column
in 2 way slab can additional compressive reinforcement can be provided if yes than in which conditions it is required ?
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
how many re use can use shutting material. timber ? ply? steel? plastic? fibre? aluminium? Doka?
Floor tile measurement? Wall to wall or skirting to skirting
