While testing concrete cubes why the load will be applied on
the opposite face of the casting surface of the cube?
- 6 Answers
- 8657 Views
- I also Faced
- E-Mail Answers
Answer Posted / himanshu sekhar pradhan
Because pouring surface plained by manually, which never
be so smooth to applied load equally through out the
surface that create maximum failure.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
What is the use of water table & Kreb stone for drain
types of piles detail,
How do you determine specific gravity of cement?
How to convert 20 dia bar to 16 dia bar in beam without reducing the steel weight
If we have the center line of the Finnish road level and we want to know what level of pay would have offset the Lhs and Rhus RHS 1,2.5,5 1,2.5,5 m.
Mention what are the composition of a landfill?
HOW MANY BAGS OF CEMEMT USED IN PER M2 OF PARTITION WALL
How many hours should traffic be not allowed after completing wbm road or bst.and min how many hours should road rollers be used.
Moisture content calculation for diff mix ratio's ??
What distance in meters on the ground is the equivalent of one second of arc in longitude or latitude?
Slump Values for works?
What is OSHA compliance?
how clculate excavated or backfilling quantity by simpson's rule
how much percent are used 20mm,10mm?
