Why we transmit the power at the voltage in the multiple of
11 or 1.1 like 11kv, 22kv, 66kv, 132kv...... some one told
me that it is due to fomr factor 1.1 of sine wave. its fine
but while transforming we can choose any voltage, so why
only multiple of 1.1 there also.......? plz tell me.
Answer Posted / baskar
i think this is standared voltage our country .in abroad
the frequency is 60 Hz
Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
What is EHT tariff or Power factor Tariff ????
What is signal flow graph?
What current position are you holding in your current company?
State ohm’s law?
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
what is the thumb rule for determination resistance of resistor?
What is the general system requirement of alternator?
can i use ups power as a raw power for another ups
what is sustainable current of any conductors . a bare busbar or pvc cable has different sustainable current .
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how to increase or decrease speed in DC shunt motor by DC convertor
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
how we do Vector group ,magnetic balance and tap changer test in Transformer?