what is the technical term when and alternator's prime mover
fails.
Answer Posted / ramesh k mahto
overloaded
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is the function of the circuit breaker failure relay?
what is the difference between circular wdg & ractangular wdg?
Discuss about gear cutting machines.
Difference between On Line capacitor and Station Type capacitor.
How can find thermal state value in relay for calculate thermal overload.
Define open loop control system.
On what cycle does thermal power plant operate?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
What is meant by bus bar protection?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
difine electrical ballast in HPSVL
what is the formula of starting current of 3phase and 1 phase motor???