What is OLTC in transformers and what is its function?
Answer Posted / er. bhabani shankar behera
OLTC is on line tap changer.it in normally connected in hv
winding.becz in order to minimize the sparking during tap
changing.as current is less in hv winding a compared to lv
winding.it helps in changing no. of turns during loading
condition.in order to very the out put voltage as per desire.
Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
what is the meaning of impedance protected in instrument cooling fan
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
how to operate and maintenance of 1500 kva diesel generator set
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
What is the purpose of stand by earth fault protection for transformer ?
What is the general system requirement of alternator?
Installation method of self treated earth electrode.
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
What is 11 N1 and 12 N2 in single phase Transformer ?
how to read idmt curva
how to select the no. of brushes in a lap winding?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.