What phase difference between p and s
winding of transformer
- 1 Answers
- 4624 Views
- MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / rehmat
the phase difference between the P & S of the transformer is 180 degree.
| Is This Answer Correct ? | 23 Yes | 1 No |
Post New Answer View All Answers
How to connect the chemical earthing and complete process tell me plz
Why 3 phase induction motor getting supply in body if one of it's phase is cut
What is mason's gain formula?
How is the percentage impedence of a transformer fixed at design stage???
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
How many gap between finger contact in a.c.b. and v.cb.?
How can we checked Killo Watts of Motor & Alternator?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
How to checked frequency drive output voltages?
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
