If the average power during generation is zero, why do the
analog meters have + and - ?
- 1 Answers
- 4009 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / banerjeenandan
The average power during generation is never zero. The load
is never 100% resistive. It has capacitive as well as
inductive components also. The power drawn by only resistive
load is active power and the power drawn by inductive load
is reactive power. The resultant is never zero.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How to calibration a control valve?
sir, give me placement papers and interview quistion of birla group company of copper.
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
what is sliding spool valves?
what is the reset offset and control system in instrumentation
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
Make Heater Process Logic.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
why I need valve guard and whats different between guard and positioner ??
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
What is loop1 and loop2 in MTS LT?
Gas equation
